Three Methods Of Precision Adjustment Of Planetary Reducers

Jun 11, 2025 Leave a message

There is friction when there is movement, and friction will cause changes in size, shape and surface quality between related parts, resulting in wear and increasing the mating gap between related parts. When the gap exceeds a reasonable range, the accuracy of the relative movement between parts can only be ensured by adjusting the gap. Below, I will share with you three methods of precision adjustment of planetary reducers.

1. Adjustment of guide rail guidance accuracy:
For ordinary mechanical equipment, whether the gap between the sliding guide rails is appropriate, usually use a 0.03mm or 0.04mm thick feeler gauge to insert at the end face for inspection, and its insertion depth should be less than 20mm. If the rail clearance is not suitable, it must be adjusted in time.

2. Adjustment of the gap between the lead screw and the nut:
Lead screw nut drive is a common mechanism that achieves linear motion. The combination of the lead screw and the nut is difficult to achieve without gaps. Especially after a stage of use, due to wear, the gap will increase, affecting the normal operation of the equipment. Therefore, during equipment maintenance, it is very necessary to pay attention to eliminating the gap between the lead screw and the nut.

3. Adjustment of the rotation accuracy of the spindle of the planetary reducer:
The rotation accuracy of the planetary reducer spindle is generally determined by the bearing under the premise that the machining error of the spindle itself meets the requirements. The key to adjusting the rotation accuracy of the spindle is to adjust the clearance of the bearing and maintain a reasonable amount of bearing clearance, which is of great significance to the working performance of the spindle components and the life of the bearing.

For rolling bearings, working with a large clearance will not only concentrate the load on the rolling element in the direction of stress, but also produce serious stress concentration phenomenon at the contact of the inner and outer ring raceways of the bearing, shorten the bearing life, and cause the centerline of the spindle to drift, which is easy to cause vibration of the spindle components. Therefore, the adjustment of rolling bearings must be preloaded, so that a certain interference amount is generated inside the bearing, resulting in a certain amount of elastic deformation at the contact between the rolling element and the inner and outer ring raceways, so as to improve the rigidity of the bearing.